Description
Fan Plus 50 Plus Furnace Fan Control Board
FAN 50 Plus
Replacement Ignitor Board w/Fan Control for Hydroflame & Suburban Furnaces
When this board senses a “failure to ignite” or “loss of flame” condition it will wait one minute and shut the fan motor off instead of blowing cold air and maybe running the battery down. It replaces Dinosaur Electronics previous large and small Fan boards as well as the newer OEM Fan boards used in some Atwood®/Hydro-Flame® furnaces. The board is fuses, and a diagnostic LED on the board glows “GREEN” when power is applied to the board and turns “RED” when the board Activates the gas valve.
THE FAN FEATURE MUST BE USED WHEN INSTALLING THE FAN 50 PLUS.
Ignition Control Circuit Board; Replaces Dinosaurs Earlier Small And Large Fan Boards; Can Also Be Used To Replace The Present Fan Control Ignitor Boards Being Used By Suburban\ Atwood\ Hydroflame
The FAN 50 Plus Pins is designed to replace the new Suburban® and Atwood® / HydroFlame® Fan Control boards as well as maintain backward compatibility with the Fan 50 Plus, and UIB Fan Control boards which have been available since 1994. This board can also be used to upgrade older furnaces to add the Fan Control feature. The basic purpose of a Fan Control Ignitor Board is to shut the fan motor off if the board fails to sense a flame after the third ignition try. Thus, battery drain is reduced and the needless blowing of cold air is eliminated.
Features
- Used To Upgrade Older Furnaces To Add The Fan Control Feature
- Fan Plus 50 Plus Furnace Fan Control Board
- Shuts The Fan Motor OFF If The Board Fails To Sense A Flame After The Third Ignition Try
- Battery Drain Is Reduced And The Needless Blowing Of Cold Air Is Eliminated
- Compatible With The Fan 50 Plus And UIB Fan Control Boards
- Limited 3 Year Warranty
Warranty Terms: 3 Year Factory Warranty
