Description
Intellitec 50 Amp EMS Display Panel, 00-00903-250
When the power is available, the LED will be on. The panel includes a switch to select operation from 30 amp or 20 amp service. This panel is easily connected with
a small four conductor harness.
The Intellitec 50 Amp EMS Display Panel, 00-00903-250 can be mounted remotely and connects to the Control Module with a small gauge, four wire cable.
Four Power Status LED’s indicate whether power is applied to those
loads. These LED’s are on when the power is applied.
Intellitec 50 Amp EMS Display Panel, 00-00903-250
A two digit display, the Load Meter, indicates the amount of
current actually being drawn by all the appliances in the coach.
The Service Select button allows the current threshold to be set
to either 30 Amps or 20 Amps, to match the incoming service. When power is first
applied, the system will always be in the 30 Amp mode. Momentarily pressing this
button will switch the system to the 20 Amp mode.
Four Service Type LED’s indicate the type of service that the
system is operating under. If the GEN SET service indicator is lit, the system
has automatically detected the presence of 120 VAC at the L1 and L2 inputs and
the presence of the +12 VDC run signal from the generator at the GEN SET input
on the Control Module. If the 50 AMP service indicator is lit, the system has
automatically detected the presence of 240 VAC at the L1 and L2 inputs on the
control module. If the 30 AMP service indicator is lit, the system has
automatically detected the presence of 120 VAC at the L1 and L2 inputs and the
absence of the +12 VDC run signal from the generator input on the Control
Module. If the 20 AMP service indicator is lit, the user has selected that mode
by momentarily pressing the 20/30 Amp select button. Momentarily pressing this
button again will switch the system back to the 30 Amp mode.
Intellitec 50 Amp EMS Display Panel, 00-00903-250
This panel can also be used to display the value of current stored
in memory for each of the four loads.
